![]() We will replace all defective items that meet our return/replacement requirements, but will not accept any liability for loss or inconvenience caused by their use or failure. Buyer shall notify T1 Race Development immediately upon discovery of any product defect.ĭefective items must be returned for replacement in accordance with our return policy and at buyer’s expense. Additionally, there is no warranty on electrical parts. ![]() ![]() There is no warranty, expressed or implied, on any parts used for competition or track events. Parts purchased used or purchased through unauthorized distribution channels will no longer carry a warranty whatsoever. T1 Race Development will pass this warranty on to the original buyer. Many products carry a manufacturer’s warranty. T1 Race Development has carefully chosen its product offerings, and all products are guaranteed to be first quality merchandise. ![]() Any length away adds delay and possible incomplete release. Mount CO2 regulator as close as possible to air cylinder for proper function. The higher the psi the faster and better the function of this system. CO2 handle release is meant to operate at conditions of 80psi and higher. Failure to test before hand, and/or constrictive bends, can cause the handle to operate slower or incorrectly. Cable needs to have loose swooping bends. Note: Please test operation prior to going to the racetrack. Optional: Second Cable/Hardware and Push Button CO2 Solenoid weld or clamp on mounting bracket.Cable with necessary connection hardware.Improper installation, hookup, or misuse may result in improper function of this part. The biggest thing is you need to TEST this before heading to the track. Please note that, even though this kit is supposed to be a complete kit and has been strenuously tested, refined, and appropriately changed to work under the demand of today's chassis, care needs to be taken when installing. Our design of this kit was made to operate under 80 psi, though it operates better the higher you go up to 120psi. When installed properly this release kit will make for simple, reliable, release of your parachute while keeping both hands firmly planted on the wheel. This kit is designed to weld or clamp on and provides a complete solution with no guess work or additional fabrication.Īvailable in both single and dual cable styles. When its is most important to pay attention to the track and things are moving fast, launch your parachute with the push of a button rather than taking your hand off and trying to find a handle mounted above/out of the way of eyesight. The ALL NEW Motion CO2 Release Handle Kit is the answer to keeping your hands on the wheel at the big end of the track. GT1R Motion Raceworks Billet C02 Activated Parachute Release Handle Kit Our goal is to ensure that our all of our customers have a tried and true experience with their Nissan GTR's performance. This is a very standard fitting size across brands such as Tial, JGS, Precision, Turbosmart, Procharger,and many others.T1 Race Development does all of it's own research and engine development in-house, on our own vehicles. Our nickel plated fittings are 1/8 NPT which work with nearly every brand wastegate, blow off valve, and solenoid on the market. The C02 regulator comes preset at 80 psi which is appropriate for nearly every setup (the boost controller regulates pressure down from there). There are enough fittings in this kit to plumb the following. This all inclusive kit comes with top quality fittings, regulator, line, and bottle to plumb any Boost Controller system on the market. The Motion Raceworks Single Turbo C02 Kit takes the guess work out of fittings. MOTION RACEWORKS SINGLE TURBOCHARGED C02 KIT
0 Comments
Leave a Reply. |